Breakout Boards are a convenient, re-usable solution for wiring multiple igniters to a single cue.

Includes:

• 1 x Breakout Board
• 1 x Quickplug Harness

×

Quickplug Harnesses for use with a Breakout Board. Available in 1ft, 6.5ft, & 19.5ft.

Take your show prep to the next level with the Quickplug 6-Cue Visualizer. Designed to work seamlessly with the IGNITE i18 and i36 modules, this tool provides a clear visual representation of your firing cues.

You can use up to three Quickplug 6-Cue Visualizers with the IGNITE i18 module or up to six with the IGNITE i36 modules.

• Instant Visual Confirmation: Six blue LEDs, labeled 1 to 6, light up when cues are fired, giving you immediate feedback.
• Continuity Check: After plugging in the Visualizer, you can test each cue by pressing a button in the app. This confirms that the cue on the module is functioning correctly and ready to fire an igniter. The process for checking continuity may differ depending on your app version. For the latest instructions, please refer to our continuity check guide.
• Pre-Show Verification: Use the Visualizer during your dry run before your show to ensure all cues fire correctly, providing confidence that your setup is flawless and ready for the performance. Visualize each cue firing to confirm your script is accurate and your show will perform as desired.

The Quickplug 6-Cue Visualizer is the perfect way to prepare for your show, simulating your module firing as it would during your display. Enhance your IGNITE experience and gain peace of mind, knowing your setup is ready for a flawless performance.

×

Antenna Cable used to relocate the antenna connector to outside an armored case such as the Pelican 1050 micro case (sold separately). To drill a hole in the case, use a 1/4" drill bit.

IGNITE does not sell protective cases; however, if you want one, we recommend purchasing the case and antenna cable on your own and creating it at home. Links to the products needed and instructions are below.

Only three items are needed to make your own protective case:

• Armored Case External Antenna Cable
• Armored case, such as the Pelican 1050 micro case
• 1/4" drill bit

Use the 1/4" drill bit to drill a hole anywhere on the case (we recommend utilizing the top left corner, but you can place this anywhere the cable reaches.) After drilling a hole, install the Armored Case External Antenna Cable in the hole. Be sure to use both the lock washer and locknut. After the cable is installed, please attach it to your i18 and place it inside the case. You are done!

×